Automatic pump controller PC-10P

Automatic device controlling the operation of surface and deep-well pumps. Replaces the pressure switch and hydrophore tank. Turning on the tap sends a signal to the PC-10P controller, which starts the pump. Turning off the tap causes the PC-10P to switch off the pump. Unlike the others, the controller can operate with single-phase pumps with a power of up to 2200 W, whose current consumption during operation is up to 16 A. The device has a dry-run protection function. When there is no water in the well, the controller will switch off the pump. The PC-10P is equipped with a 1" diameter connector. The device comes equipped with a 1 m long cable with a plug and a 60 cm long cable for connecting the pump with a socket.

Automatic pump controller PC-20P

The switch is equivalent to the PC-10P, but equipped with 1¼" connections.

• suction/discharge port 1" (type PC-10P)
• suction/discharge port 1¼" (type PC-20P)
• supply voltage ~230 V
• Ingress protection: IP65
• max. water temperature 40°C
• switch-on pressure 1,5 bar
• permissible max. pressure of the system 10 bar
• max. current: 16 A
• Built-in check valve
• dry-running protection
• built-in pressure gauge (only type PC-20P)
• manual RESET switch
• LED indicating POWER supply
• LED indicating pump operation ON
• LED indicating FAILURE
• automatic restart (only type PC-20P)